MacDon R80 - Step 6. Unpack Hitch

UNLOADING AND ASSEMBLY
Form # 169080 Issue – April 2007
13
STEP 6. UNPACK HITCH
a. Attach chain from lifting vehicle or hoist to hitch
hooks, and raise it two feet off ground.
b. Cut banding securing hydraulic motor and
hoses to underside of hitch.
CAUTION
Hold motor to keep it from dropping to the
ground when cutting band around motor.
c. Route motor and hoses to the left side of the
hitch.
d. Secure the motor to the steering cylinder with
shipping wire.
e. Remove the two bolts securing wooden stand
to hitch pin.
NOTE
Bolt and washer at top of pin keeps pin
in hitch when bolts are removed.
f. Cut banding securing wooden stand to hitch
and remove wooden stand.