EasyManuals Logo

Magellan eXplorist 310 User Manual

Magellan eXplorist 310
39 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
Magellan eXplorist 310 User Manual 1
Using the Magellan eXplorist
The Magellan eXplorist GPS receiver is designed to be easy enough for the casual ‘explorer as well as having
all of the advance features the ‘enthusiast’ requires. This chapter provides information on the basics of using
the Magellan eXplorist GPS receiver.
Use of the Joystick to select or ENTER. Throughout this manual you will be asked to ‘select’ a button or icon.
This is done by using the joystck (left, right, up, down) to highlight the item on the display. Pressing down on the
joystick provides the ENTER command to the receiver.
Installing the Batteries
The Magellan eXplorist GPS receiver uses two
AA batteries that provides 16 hours of normal use.
(See the section on Power Settings for details as to
how to extend the battery life.) Lithium, alkaline or
rechargeable batteries can be used but both batteries
need to be of the same type and should be dened
in the Tools > Power function in the receiver (see
Setting Battery Type).
Replacing the Batteries
1. Remove the battery door by raising the arm
on the battery door lock and turning it counter
clockwise for one-quarter of a turn.
2. Remove the battery door. The battery door
pivots from the bottom. The pivot points will
release when the top of the battery door is
being raised.
3. Install two AA batteries as shown.
4. Replace the battery door by rst aligning the
pivot tabs at the bottom of the door with the
receiver.
5. Lower the battery door until it seats rmly
against the receiver. (Note: you may need to
turn the battery door lock counter clockwise to
allow the door to seat against the back of the
receiver.)
6. Turn the battery door lock clockwise, locking
the door in place.
Setting the Battery Type
1. Press and hold the Power button (top left of
the receiver) for 2 seconds.
2. With the receiver on and the Map screen
displayed, press the BACK button.
3. The Menu screen is displayed. Use the joystick
to highlight the Tools icon. Press the joystick to
Enter.
4. Select Settings (use the joystick to highlight
Settings and press the joystick for Enter).
5. Select Power.
6. Select Battery Type. A drop-down menu is
displayed.
7. Select the type of battery installed: Alkaline,
Rechargeables or Lithium.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Magellan eXplorist 310 and is the answer not in the manual?

Magellan eXplorist 310 Specifications

General IconGeneral
Golf-
Sport (fitness, running)Yes
Marine (chartplotters, sounders)No
Tracks quantity1
Number of waypoints500
GPS accuracy - position5 m
Map coverageWorld
Display diagonal2.2 \
Display resolution240 x 320 pixels
Storage media typeFlash
Internal storage capacity0.5 GB
Processor modelSiRFStar III
Processor frequency400 MHz
Form factorHandheld
Product colorGrey, Orange
International Protection (IP) codeIPX7
USB 2.0 ports quantityUSB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Battery typeAA
Power source typeBattery
Battery life (max)18 h
Battery technologyAlkaline
Number of batteries supported2
Operating temperature (T-T)-10 - 60 °C
Weight and Dimensions IconWeight and Dimensions
Depth36 mm
Width56 mm
Height111 mm
Weight147 g

Related product manuals