Magellan eXplorist 310 - Settings - Tracks, Alarms, and Controls; Track Logging and Alarms; Input and Compass Settings

Magellan eXplorist 310 User Manual 19
eXplorist Tools
The Magellan eXplorist has a Tools Menu that gives you access to tools that you may nd useful while using
thereceiver. Additionally, the Tools Menu provides access to the Settings Menu (see the chapter on Settings for
details) which gives you the means to customise the eXplorist for your navigation requirements.
The Tools Menu
Accessing the Tools Menu
1. From the Map screen, press BACK.
2. Select Tools.
3. The Tools Menu is displayed.
Settings
Provides access to the Settings Menu which allows
for customisation of the receiver.
Accessing Receiver Settings
1. Access the Tools Menu.
2. Select Settings.
( See the chapter on Settings for details. )
Track Summary
Provides detailed statistics for the current active track.
Viewing Track Summary
1. Access the Tools Menu.
2. Select Track Summary.
Geocache Summary
Provides detailed statistics for all geocaching
activities performed while using the eXplorist receiver.
Viewing Geocache Summary
1. Access the Tools Menu.
2. Select Geocache Summary.
Waypoint Projection
A waypoint can also be created by entering the
distance and heading for the waypoint from your
current location.
Projecting a Waypoint
1. Select the Bearing eld. Use the keypad
toenter the degrees that the projected waypoint
is from your current position.
2. Select OK.
3. Select the Distance eld. (Note that you can
select the units of measure drop-down menu to
change the units to be used.)
4. Use the keypad to enter the distance from
your current location that you want to project a
waypoint.
5. Select OK.
6. Select Next>.
7. The Waypoint Description page is displayed.
Make the necessary edits and select the Disk
icon at the bottom to save.