Magellan eXplorist 310 User Manual 22
Settings
The Magellan eXplorist has a Settings Menu that allows you to customise how the eXplorist displays
information, run diagnostic tests and other useful functions that will enhance your navigating experience.
The Settings Menu
Accessing the Settings Menu
1. Press the BACK button from the Map screen.
2. Select the Tools icon at the bottom of the
menu.
3. Select Settings from the Tools Menu.
4. The Settings Menu is displayed.
Settings
Brightness and Volume
Adjusting the Brightness
1. Access the Settings Menu.
2. Select Brightness & Volume.
3. Use the Brightness slider to increase or
decrease the display intensity.
Setting the Backlight Timer
The Backlight Timer turns the backlight off, saving
battery life, if no buttons have been pressed in the
time selected.
1. Access the Settings Menu.
2. Select Brightness & Volume.
3. Select the Backlight Timer drop-down menu
and select the duration that the backlight will
remain on without button having been pressed.
Adjusting the Volume
1. Access the Settings Menu.
2. Select Brightness & Volume.
3. Highlight the Volume slider and use the joystick
to increase or decrease the speaker volume.
Muting the Volume
1. Access the Settings Menu.
2. Select Brightness & Volume.
3. Select the Mute button. When checked the
volume is muted.
Power
Setting the Active Suspend Timer
This sets the duration that the receiver will remain
on before going into active suspend mode if no
buttons have been pressed. Active suspend puts
the receiver in a power save mode but continues to
record your track.
1. Access the Settings Menu.
2. Select Power.
3. Select the Active Suspend Timer drop-down
menu and select the duration that the receiver
will remain active without a button having been
pressed.
Setting the Power Off Timer
This sets the duration that the receiver will remain
on before powering off if no buttons have been
pressed.
1. Access the Settings Menu.
2. Select Power.
3. Select the Power Off Timer drop-down menu
and select the duration that the receiver
will remain on without buttons having been
pressed.