MG6250 • Section Programming Guide
Version 1.6
System Programming | 31
Dialer Options
Section
Option Description
OFF ON
[2006]
1 & 2
Telephone line monitoring options
1 2
TLM disabled OFF OFF
Trouble only ON OFF
Disarmed: Trouble only
Armed: Audible alarm
OFF ON
Silent alarms become audible ON ON
3 Switch to pulse on fifth attempt Disabled Enabled
4 Software call back Disabled Enabled
5 Remote arm/disarm on incoming call Disabled Enabled
6 Force dial Disabled Enabled
7 DTMF dialling Disabled Enabled
8Pulse ratio 1:2 1:1.5
Section
Option Description
OFF ON
[2007]
1 Landline reporting enabled Disabled Enabled
2GSM reporting enabled Disabled Enabled
3GPRS reporting enabled Disabled Enabled
4 Future use - -
5 Future use - -
6 Arm/disarm via SMS Disabled Enabled
7 Future use - -
8 Contact ID override Disabled Enabled
Section
Option Description
OFF ON
[2008]
1 & 2
GPRS Monitoring Options
1 2
GPRS monitoring disabled OFF OFF
Trouble only ON OFF
Disarmed: Trouble only
Armed: Audible alarm
OFF ON
Silent alarms become audible ON ON
3 & 4 Future use - -
5 Live event encrypted on external serial port Disabled Enabled
6 Live events on external serial port Disabled Enabled
7 Live events on modem (when connected) Disabled Enabled
8 Live events on GPRS (when connected) Disabled Enabled
Section
Option Description
OFF ON
[2009]
1 Restrict arming when zone opens during exit delay Disabled Enabled
2Ack trouble(s) before arming Disabled Enabled
3 Future use - -
4 Future use - -
5 Future use - -
6 Future use - -
7
GSM Antenna* Internal External
8
RF Frequency** 868 MHz Enab
* If you are using a GPRS14 on an 868 MHz console, you cannot use GSM as a communication method when armed, unless an external antenna is connected. Once
the antenna is connected, you must set section [2009], option [7] to ‘ON’, or ‘external’.
** The frequency of the console cannot be changed, but must be programmed accordingly. Refer to the sticker on the console to view the set frequency, then
program it in option [8].
To Next Page
Loading...
