MG6250 • Section Programming Guide
Version 1.6
Description of MG6250 Events | 35
Description of MG6250 Events
The following tables provide a listing of the events that can occur on the MG6250 Console.
NOTE: In the Area column, 1 and 2 refer to areas 1 and 2, respectively; whereas 3 refers to both partitions.
Non Reportable Events/Non Saved Events
Table 10: Non Reportable Events/Non Saved Events
Event Event Description Sub-event Sub-event Description Area
00 Zone OK
01 - 64
99
Zone number 1, 2, 3
01 Zone open
02 Partition status
02 Silent alarm
1, 2, 3
03 Buzzer alarm
04 Steady alarm
05 Pulse alarm
06 Strobe
07 Alarm stopped
08 Squawk ON
09 Squawk OFF
10 Ground start
11 Disarm partition
12 Arm partition
13 Entry delay started
14 Exit delay started
15 Pre-alarm delay
03 Bell status
00 Bell OFF
1, 2, 3
01 Bell ON
02 Bell Squawk (once)
03 Bell Squawk (twice)
04
05
To Next Page
Loading...
