Magner 150 - User Setting and Configuration; Accessing User Settings

User’s Manual MAGNER150
- 35 -
7. USER SETTING MODE
7-1. How to set the User Setting Mode
Serial RJP CF
--------------------
0
0
$
0
--------------------
B100 ---
+10 -> USER MENU
PRINT -> PRINT MENU
Press and hold down +10 Key.
By pressing and holding down +10 key in
any mode, you can enter special mode.
Display of special mode
Press +10 Key to enter USER MENU
USER SETTING MODE (1/2)
------------------------------
>>1.EXIT(PRESS RESTART KEY)
2.ID --- NONE
3.USER s ID PRINTING - *YES
4.REJECT POCK. ACTIVE - *YES
5.REJECT POCK. SIZE - *60
6.NUMBER OF PRINTOUT - *1
7.PRE-BATCH PCS. SETTING
8.SCREEN SAVER^^^- NONE
9.BUZZER VOLUME^^- Middle
------------------------------
NEXT PAGE – BATCH KEY
When you press RESTART•STOP key after changing a setting value, Display
shows the message “Wait… Setting Data Saving…”
Menu selection: MODE key
Value selection: PRINT, +10 or +1 key
USER SETTING MODE (1/2)
------------------------------
1.EXIT(PRESS RESTART KEY)
2.ID --- NONE
>>3.USER s ID PRINTING - *YES
4.REJECT POCK. ACTIVE - *YES
5.REJECT POCK. SIZE - *60
6.NUMBER OF PRINTOUT - *1
7.PRE-BATCH PCS. SETTING
8.SCREEN SAVER^^^- NONE
9.BUZZER VOLUME^^- Middle
------------------------------
NEXT PAGE – BATCH KEY