Engineered XLTX Transmitter Instruction Manual
December 2016
Page 39 of 49
Receiving (Reading) the XLTX Programming
To read a program file from the XLTX Transmitter:
1. Plug in the USB programming cable and turn the unit on.
2. Click “Receive” and follow on-screen prompts.
3. RCP will confirm reception and automatically display current programming in the XLTX
unit.
Reading the RCP Software Version
1. Select “Help”.
2. Select “About”.
3. The RCP Software Version number will be displayed.
Resetting XLTX Back to Factory Default Settings
1. Select “Reset to Defaults” button.
2. A dialog box will pop up confirming that you want to proceed. Click the button “OK” to
restore the factory default settings. On-screen prompts will confirm that the transmitter
has been reset to defaults or if there are any issues.
3. Power cycle the XLTX transmitter to implement the factory default values.
NOTE: Resetting the system back to factory defaults only restores the factory settings for the
CAN configuration settings. All other settings will not be altered.
To Next Page
Loading...
