Engineered XLTX Transmitter Instruction Manual
December 2016
Page 25 of 49
The user will see a prompt for a four digit password if the password feature is enabled. If no
password is enabled, then the adjustments in Section 4.2.2 will be available with no further input
required from the user.
NOTE: The password feature is enabled by default from the factory.
Use the Joystick/Paddle to increment/decrement the value and toggle to the START position
when finished. If the password is entered correctly, the device will enter Setup Mode. If it is
entered incorrectly, the device will power down.
NOTE: The factory default password to get into the setup menu is 0000.
4.2.2 Adjusting Settings in Setup Mode
To navigate through Setup Mode, the Joystick/Paddle designated (MTN 1 or first MTN number
utilized on project prints) and OFF-ON-START switch are used. The Joystick/Paddle cycles
through the menus and is also used to change parameters within the menus. Pushing the OFF-
ON-START switch to the START position will toggle between the menu and its parameter(s).
When adjusting larger values, the speed is dependent on how far the Joystick/Paddle is
depressed.
NOTE: No parameter changes will take effect until the user has selected ‘Save and Exit’ from the
Setup Mode.
4.2.2.1 Access Code
The Access Code determines which receiver will be controlled by the transmitter.
The Access Code in the XLTX transmitter must match the receiver Access Code or dip switches.
If the Access Code settings on the receiver and transmitter do not match, no communication will
occur.
The Access Code is a 20-bit binary value with a decimal equivalent of 0 - 1048575. It will be
displayed as binary or decimal depending on the application.
4.2.2.2 Channel Select
The Channel Select setting determines the frequency on which the XLTX is operating.
The user can select channels 1 through 32, which correspond to the frequencies in Section 6.2.
4.2.2.3 User Code
The User Code setting is a unique identifier that allows the user to select multiple modes when
using the same channel. The receiver can be tuned to only ‘hear’ messages sent from a
transmitter with the same user code.
4.2.2.4 Transmitter Timeout
This setting controls the amount of time that the transmitter can be inactive before it automatically
shuts off. Factory default is 15 minutes, unless your project specific drawing states otherwise.
The Timeout time can be set from 1 to 60 minutes.
When the unit times out, the transmitter will turn off.
.
To Next Page
Loading...
