10-8
© Copyright Mahindra & Mahindra Ltd.012016
A/C LO A/C HI
W12J09
MANUAL
FATC
Auto Climate Contr ol System
W12J27
10.10.1 Fresh Air Mode (Outside Air Mode)
To set the HVAC system to fresh air mode, keep the air intake
control switch in the OFF condition. The lamp on this switch does
not illuminate, indicating that the fresh air mode is active.
In this intake mode, fresh air from outside the vehicle is sucked by
the blower and utilized further to ventilate/cool/ heat the cabin.
The re-circulation mode is activated by default every ignition
cycle.
10.10.2 Re-circulation Mode (Re-circulated Air Mode)
To set the HVAC system to re-circulation mode, press the air intake
control switch once. The lamp on the switch gets illuminated,
indicating that re-circulation mode is active.
In this intake mode, the air from inside the passenger compartment
will be sucked by the blower and utilized further to ventilate/cool/
heat the cabin.
Pressing the switch again will revert the system back to fresh air
mode and lamp will go OFF.
For quick cabin cooling/heating or while driving through dusty/
polluted regions, the recirculation mode can be selected. Driving
with this mode active may lead to better fuel economy and longer
HVAC filter life.
However, running the air conditioner in the re-circulation mode for
long will make the cabin air too dry and the oxygen level drops inside
cabin turning the air stale. On the contrary, keeping air intake
control in the recirculation mode for long, with the air conditioner
HEATING, VENTILATION AND AIR-CONDITIONING SYSTEM (HVAC)
To Next Page
Loading...
Need help?
General
