Disposing of the Accessory 2-6
Repackaging the Accessory 2-5
O
Operating principle 5-1
Operator 1-1
P
Pause Time 7-4
Physical dimensions A-1
Power requirements A-1
Power up the Accessory 3-8
Presentation code 7-1
Pump speed display 4-2
Q
Qspec logo 4-3
Qspec MS1 macro 4-4, 6-1, D-1
Installation D-1
R
Rear panel 4-3
Digital I/O connector 4-4
Dispersion Unit connector 4-3
Fuse 4-4
Mains input connector 4-4
Mains on/off switch 4-3
Mains power cable 4-3
Mains voltage selector 4-4
Reassembly 9-4
Repackaging the Accessory 2-5
S
Safety warnings
Laser Warnings 2-2
Safety warnings 2-3
Electrical safety warnings 2-3
Sample filename 7-1
Sample handling 2-3
Sample out 4-2
Sample preparation 8-1
Slurries 8-2
Trapped air/bubbles 8-1
Ultrasonics 8-2
Sample return 4-2
Sample’s units 7-3
Site requirements 2-1, 3-1
Software 4-4
Qspec MS1 macro 4-4
Solvent name 7-3
SOP - see Standard Operating
Procedure
Specifications A-1
Replacing the fuse A-1
Speed control 4-2
Standard Operating Procedure 4-4, 6-1, 7-1
Accessory name 7-1
Background Sweeps 7-2
Date & Time 7-5
Dispersant Name 7-3
Dispersant Quantity 7-3
Editing & Deleting a SOP 7-5
Lens 7-2
Max Obscuration 7-5
Measurement Quantity 7-3
Measurement Sweeps 7-2
Min Obscuration 7-4
Pause Time 7-4
Presentation code 7-1
Sample filename 7-1
Sample’s units 7-3
Solvent name 7-3
Stirrer Speed 7-2
Surfactant concentration 7-4
Surfactant Name 7-3
Surfactant Quantity 7-4
Ultrasound duration 7-4
Stirrer Speed 7-2, A-1
Supervisor
Malvern personnel 1-1
Surfactant concentration 7-4
Surfactant Name 7-3
Surfactant Quantity 7-4
System and Accessory preparation 6-1
Flushing the Accessory 6-1
INDEX
QS Small Volume Sample Dispersion Unit
Page 2
MAN 0161
To Next Page
Loading...
