1110
2.7 Gimbal Balancing
⚠
Before balancing the Gimbal, lock the Gimbal to the balance lock state
at first, unlock each axis positioning lock in stages during the balancing
process.
(1) Before balancing the Gimbal, the lens cover should be removed from the
camera and the memory card needs to be inserted to the camera to complete
all the connections to ensure that the camera is ready for shooting.
(2) During balancing the Gimbal, make sure the camera is powered off and the
Gimbal is turned off.
(3) If you add accessories after the balancing is completed, Gimbal will need to
be re-balanced.
TIPS
2.7.1 Balance Adjustment of the Tilting Axis
(1) a. Unlock the tilt axis positioning lock ①, place the camera lens vertically
upwards, determine the camera's center of gravity.
b. Loosen the sliding arm lock screw ②, slide the sliding arm ③ to balance the
camera position.
c. Tighten the sliding arm lock screw ②, if the camera lens can stay vertically
upwards that means balanced.
To Next Page
Loading...
Need help?
General
