Manfrotto MVG460 - Start to Use; Battery Charging; Battery Installation

76
2. Start to use
⚠
Read the detailed manual before using this products.
(1) Please install the camera before powering on the Gimbal.
(2) When the battery is low, please charge the Gimbal.
(3) When not in use, turn off the Gimbal and then remove the batteries.
(4) For quick start, utilising MVG640 basic features follow the steps below.
TIPS
2.1 Battery Charging
Charge the batteries with charger.
*Please fully charge the batteries before power on the Gimbal for the first time.
Micro USB
Cable
(not included)
2.2 Battery Installation
Remove the tail cap, open the batteries compartment, and install the batteries
correctly.
⚠
Please fully charge the
batteries before powering on
the Gimbal for the first time.