Manitou MT 625 H 75K ST5 S1 - Page 118

3 - 32
CHECK Radiator *
CHECK Transmission pressures *
CHECK Steering *
CHECK Steering swivel joints *
CHECK Brake pad and brake disk wear *
CHECK Condition of boom assembly *
CHECK Bearings and bushings *
CHECK Condition of hoses and flexible pipes *
CHECK Condition of cylinders (leakage, rods) *
CHECK Hydraulic circuit pressures *
CLEAN Air conditioning (OPTION) *
CLEANING CONDENSER AND EVAPORATOR COILS
CLEANING CONDENSATE TRAY AND RELIEF VALVE
COLLECTING COOLANT TO REPLACE DRIER FILTER
REFILLING WITH COOLANT AND CHECKING THE THERMOSTATIC CONTROL AND PRESSURE SWITCHES
NOTE: When opening the evaporator unit, remember to replace the cover seal.
t
IMPORTANT
t
DO NOT ATTEMPT TO REPAIR ANY PROBLEMS YOURSELF. ALWAYS REFER TO YOUR DEALER WHEN REFILLING CIRCUITS, AS THEY HOLD THE CORRECT SPARE PARTS, AS
WELL AS HAVING THE NECESSARY TECHNICAL KNOWLEDGE AND TOOLS.
In any of the following circumstances, call a doctor.
If inhaled, take the victim to fresh air.
If there is contact with the skin, wash immediately with plenty of water .
If there is frostbite, apply a sterile dressing.
If there is contact with the eyes, rinse with clear water for15 minutes.
IMPORTANT INFORMATION REGARDING THE COOLANT USED
• This product contains fluorinated greenhouse gases covered by the Kyoto Protocol.
• Coolant type: R134A; it is colourless and odourless and heavier than air. Its GWP (Global Warming Potential) is1430.
• Do not allow the gases to escape into the atmosphere. Do not open the circuit under any circumstances, as this could
cause refrigerant to escape.
- The compressor has a fluid level gauge; never unscrew this gauge because it would depressurise the system. The fluid
level should only be checked when draining the system.
REPLACE Compressor belt (Air Conditioning OPTION) *
* Consult your dealer.
647732 (31/10/2019) MT 625 H 75K ST5 S1 / MT 625 H 75K COMFORT ST5 S1