Manitou MT 625 H 75K ST5 S1 - Occasional Operation; TOW or WINCH Lift Truck; SLING Lift Truck; Lift Truck

3 - 38
2
3
2
3
1
1
A B
1
1
TOW OR WINCH Lift truck
t
IMPORTANT
t
If the lift truck is not on level ground, chock it so that it does not descend the slope.
The lift truck must be towed very slowly (less than5 km/h) and for as short a distance as possible (less than100 m).
For towing a lift truck, the high pressure limiters must be unlocked to avoid damaging
the hydrostatic transmission, and the parking brake on the front axle must be released.
- Switch on lift truck ignition.
- Set the forward/reverse selector to neutral.
- Release the hand brake.
UNLOCKING THE HIGH PRESSURE LIMITERS
- Open the engine cover.
- Loosen nuts1 on the hydrostatic pump by no more than three turns.
RELEASING THE PARKING BRAKE ON THE FRONT AXLE
- Unscrew the screws2 on the front axle, remove the shims3 and fully re-tighten
the screws2.
TOWING
- Switch on the hazard warning lights.
- Since there will be no steering or braking hydraulic assistance, operate the steering
and pedal slowly, avoiding sudden or jerky movements.
- After towing, re-tighten nuts1 (tightening torque51 ft-lbs70 N.m).
- Unscrew the screws2, refit the shims3 and re-tighten the screws2 (tightening
torque70-85 ft-lbs95-115 N.m).
SLING Lift truck
- Take into account the position of the lift truck centre of gravity
for lifting.
- A = 3-11 ft-in (1200 mm) B = 3-7 ft-in (1100 mm)
- Place the hooks in the fastening points1 provided.
Ü
OCCASIONAL OPERATION
647732 (31/10/2019) MT 625 H 75K ST5 S1 / MT 625 H 75K COMFORT ST5 S1