Manitowoc Engineering Co.
ENGINE HOUR METER READING:
Start of Checklist
End of Checklist
Checkers
INITIALS
SCHEDULE
Grease all 4 hour and 8 hour lube points.
Check for damaged or missing sheet metal.
Clean and check all windows for cracks and breakage.
Clean all debris from floors, stairs, and catwalks.
Check that all machinery guards are in place.
Check radiator coolant level.
Check fuel tank level.
Check engine air cleaner service indicators.
Check that all railings, catwalks, and non-skid material are in place.
Check crawler treads for cracks, missing keepers and pins, and proper
adjustment.
Inspect rol!er path for damage and lubricate with gear oil.
Check ring gear and lubricate with open gear iubricant. , ,
Drain water fro m rotating bed sump and boom hoist housing.
Clean Cuno oil fiiter (1 or 2 places)by turning handle several times daily.
Check for fluid leaks (oil, fuel, coolant).
Fill all lubricators.
Check all oil levels (dipsticks, sight gauges, and level plugs):
Rotating bed sump.
Drum gear case.
Converter output housings.
Chain case.
Transmission case (VlCON only).
Converter reservoir (at operating temperature).
Hydraulic reservoir.
Power lowering reservoir (VICON only). '
Power lowering retarder (Non-VICON).
I
Power,lowering'chain case.
Boom hoist h0usirig (independent or standard).
Planetary gear housing (hydraUlic boom hoist only).
Chec k that the fire extinguisher on crane is fully charged.
Operator's guide and capacity charts are in operator's cab.
eCheck gauges on engines and in operator's cab for proper readings.
eCheck that machinery warning buzzer and light are operational (should come on
briefly when engine is started).
• Check all brakes for proper operation and adjustment (must hold load):
Each drum working.
Each drum parking.
Swing.
Boom hoist automatic.
Boom hoist auxiliary.
Auxiliary drum.
VlCON® tagline.
(Continued)
FOLIO
852-2
395143
To Next Page
Loading...
