Manitowoc Engineering ""
%J~.l.
t
t
t
I SCHEDULE
Drain and refill oil in transmission and transmission heat exchanger
(VICON only).
Drain and refill power lowering chain case (VICON only).
Remove and clean transmission case oilers and orifices (VICON only).
Drain and refill oil in converter reservoir, converter housing and converter
heat exchanger (VlCON only).
"C;lean converter filter, orifice filter, and suction screen (VICON only).
Drain and refill oil in converter output housings (VICON only).
Clean and lubricate flexair valves.
Clean transmission oil filter (VICON only).
Replace diaphragms in air system relay, quick release and shuttle valves.
Inspect king pin bushing for excessive wear or damage.
Drain and refill oil in drum gear case (past production).
Drain and refill oil in rotating bed sump; clean filter and suction
screen, if equipped, (Folio 1027).
Remove and clean all gear case oil nozzels.
Drain and refill oil in carbody gear cases.
Clean steering clutch pans once a year.
Drain and refill coolant in radiator and heat exchangers and
replace water filters if engine is so equipped.
Drain and refill hydraulic systems.
Clean suction screens and diffusers in hydraulics reservoirs.
Replace hydraulic filters.
:l'ighten ring gear and king pin bolts.
Service air dryer.
Drain and refill boom hoist housing.
Check boom hoist bronze gear and worm shaft for proper wear.
Check that radiator fan is correct for season.
FOLIO 852-5
395143
To Next Page
Loading...
