EasyManua.ls Logo

Manitowoc 3900W - Page 296

Manitowoc 3900W
456 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SP 18-1,
Page 2 of 3
Gear Oil
Manitowoc acknowledges that there may be boom hoist lubricants available
that are as good as, or better than, those we have approved below. However, we
have not verified the results of using those lubricants in the boom hoists on our
cranes. You are urged to consult your oil supplier before using a boom hoist
lubricant that is not approved by Manitowoc. If your oil supplier warrants that
the lubricant is in fact equivalent to the our approved lubricant and will provide
the required lubrication, then your crane warranty will not be affected.
Gear oil must meet or exceed API Service Classification GL-5 and
MIL-L-2105D.
Transmission and
Chain Case Oil
Use any 10W-30 oil that meets or exceeds the requirements of API Service
Classification CG-4, CF-4, CF-2, CF, SH and those of MIL-L-2104F.
Controlled Torque
Converter Oil
Use any 10W oil that meets or exceeds the requirements of API Service
Classification CF, CF-2, CE, CD-II, CD, SH, SG and those of MIL-L-2104F
and MIL-L-46152D.
Hydraulic Oil
Use a quality brand hydraulic oil that contains oxidation, rust, and foam
inhibitors. Additionally, the oil used must have good thermal and hydrolytic
stability to prevent wear, erosion, and corrosion of internal parts.
Units without Isolated Boom Hoist
Boom Hoist Lubricated with Oil from Rotating Bed Circulating Oil System
Lubriplate APG 80W-140 or Summit 80W-140
(both for break-in and normal operation)
Units with Isolated Boom Hoist
Boom Hoist Has Its Own Sump
Rotating Bed
Benz Oil Gear Master 80W-140 (or equivalent)
Boom Hoist Housing
Mobilgear SHC46O or Summit Syngear SH-1046 (see NOTE)
NOTE: Break-in boom hoist gears with Lubriplate APG 80W-140 or
Summit 80W-140 (contact factory for procedure). Then drain
boom hoist housing and refill with Mobilgear SHC46O or Summit
Syngear SH-1046.
ISO Grade
Hydraulic Oil
Ambient Temperature Range
15 -30
°
F to 30
°
F (-34
°
C to -1
°
C)
32 -10
°
F to 60
°
F (-23
°
C to 16
°
C)
46 0
°
F to 85
°
F (-18
°
C to 29
°
C)
68 10
°
F to 110
°
F (-12
°
C to 43
°
C)
100 30
°
F to 120
°
F (-1
°
C to 49
°
C)
395143

Table of Contents

Related product manuals