© 1999 Manitowoc Cranes, Inc.
Rev. 12-09-99 Folio 1395-1
NOTICE
CONVERTER OPERATION
CONTROLLED AND NON-CONTROLLER CONVERTERS
•
Do not exceed rated capacities on Capacities Charts for
your crane.
•
Do not increase high idle or full load engine speeds above
factory settings.
•
Do not lower load with converter any faster than load can be
hoisted with converter.
•
Do not shock load converter (suddenly apply converter
power to stop, slow down, or change direction of load).
Doing any of the above will cause excessive converter output
torque. This action will cause increased loadings on housing,
turbine, impeller blades, and sleeve valve. DAMAGE WILL
RESULT.
AVOID CONVERTER DAMAGE OR FAILURE!
395143
To Next Page
Loading...
