GROVE Published 1-20-2017, Control # 468-02 5-7
CD5515-2/YB5515-2 OPERATOR MANUAL ATTACHMENTS
SEARCHER HOOK ASSEMBLY
The searcher hook is a fixed hook that mounts to the boom
nose. The searcher hook has a maximum capacity of 6000 lb
(2722 kg).
Installation
1. Using a suitable lifting device raise the searcher hook (1,
Figure 5-10) in front of the boom nose and align the
mounting tabs (2) with the lugs on the boom nose.
2. Install the mounting pins (3) and secure with the
retaining clips (4).
Removal
1. Attach a suitable lifting device to the searcher hook
assembly.
2. Remove the lower retaining clips from the mounting pins
and remove the pins from the mounting tabs.
3. Remove the searcher hook assembly from the boom
nose.
4. Install the mounting pins into the mounting tabs and
secure with the retaining clips.
CAUTION
Do not exceed the crane stability rating shown on the load
chart in the cab.
Reference Only
To Next Page
Loading...
Need help?
General
