Part Number 80-1230-9 10/10 173
Setting Control Setpoint Value
To view and adjust setpoint, follow these steps:
1. Press MENU until the display flashes SP.
2. Press MENU again to display the existing setpoint
value.
3. Press Up or Down (arrows) to change the setpoint
value.
4. Press MENU again to save the new value. The
display returns to the sensed temperature.
NOTE: If no setup entry is made for 30 seconds, the
control reverts to the normal temperature display.
Differential, Anti-Short Cycle Delay, Temperature
Offset, or Sensor Failure Operation
To set or verify the Differential, Anti-Short Cycle Delay,
Temperature Offset or Sensor Failure Operation use
the following method.
1. Factory Preset Temperature Control Code
Settings as follows:
2. Press and hold MENU until the display changes to
flashing SP.
3. Press up and down (arrows) repeatedly until the
desired function is displayed.
4. Press MENU to display the function’s current
value.
5. Press up and down (arrows) until the desired
value is displayed.
6. Press MENU to save the new value. The display
returns to the sensor temperature.
NOTE: If no setup entry is made for 30 seconds, the
control reverts to the temperature display.
NOTE: Any saved control settings are non-volatile and
remain in the control’s memory during power
interruptions.
To Next Page
Loading...
Need help?
General
