Marantz NR1602 - Preset Code Registration: Defaults and Entry; Default Preset Code Assignments; Entering Preset Codes Manually

105
Other settings
Remote control settings
•When you connect a remote control receiver unit (purchased separately) to the REMOTE CONTROL IN
connector of this unit, use the following procedure to disable the remote sensor function of this unit.
•The remote sensor function of remote control signals is enabled by default.
SURROUND MODE
PURE DIRECTON/STANDBY
nDisabling the sensor function of the remote control unit
When the main unit is in standby mode, press ON/STANDBY while holding down
SURROUND MODE and PURE DIRECT on the main unit.
“Remote Lock:ON” is shown on the display, and the infrared light receiving function is disabled.
nEnabling the remote sensor function
When the main unit is in standby mode, press ON/STANDBY while holding down
SURROUND MODE and PURE DIRECT on the main unit.
The infrared light receiving function on the main unit is enabled.
NOTE
If a remote control receiver unit (purchased separately) is not connected, do not perform this setting. If you
do, you will not be able to operate this unit using the remote control unit.
Basic version
Advanced version
Information
Advanced version
BD