Marantz NR1602 - Advanced Playback Operations; HDMI Control and Sleep Timer; Speaker Volume and AirPlay; Networked Audio and Web Control

59
1
Set up the
remote control unit
n Set up the operation mode
Press AMP to set the remote control unit to AMP-
operation mode.
Press AMP
2
Connect the setup microphone.
MultEQ
Preparation
Connect the speakers and place then according
to the recommendations in the manual.
Next
Audyssey Auto Setup
[RETURN][ENTER] Enter Cancel
When the setup microphone is
connected, the following screen is
displayed.
3
Select “Next”, and then press
ENTER.
Set up speakers
around items indicate the settings.
This section provides the setup methods of speaker systems other than the 7.1-channel system (with surround back speakers).
For the setup methods of the 7.1-channel system with surround back speakers, see C page 4 “Setup Wizard”.
First install and connect the speakers to this unit.
Before Auto Setup measurement, the settings shown below can be made.
•Changing the amplifier assignment (Amp Assign)
The signal output from the SURR.BACK/AMP ASSIGN speaker terminal of this unit can be switched to match your speaker environment (vpage59 “Set up “Amp Assign””).
•Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced. You can also change the number of surround back speakers (vpage60
“Set up “Channel Select””).
4
Set up “Amp Assign”
Use ui to select “Amp Assign”, and then press
ENTER.
MultEQ
Amp Assign NORMAL
Amp Assign
[RETURN] Return
MultEQ
Preparation
Set the following items
if necessary.
Amp Assign
Channel Select
Audyssey Auto Setup
Auto Setup Start
[RETURN][ENTER] Enter Cancel
Basic version
Advanced version
Information
Advanced version
vSee overleaf