Marantz NR1602 - Convenient Functions: HDMI Control and Sleep Timer; HDMI Control Function Details; Sleep Timer Operation

60
Set up speakers
7
Set up “Channel Select”
Use ui to select “Channel Select”, and then press
ENTER.
Surround Back
Subwoofer
Measure(2sp)
Measure
Channel Select
[RETURN] Return
MultEQ
Preparation
Set the following items
if necessary.
Amp Assign
Channel Select
Audyssey Auto Setup
Auto Setup Start
[RETURN][ENTER] Enter Cancel
8
Use ui to select a channel.
Surround
Back
Select the number of surround back speakers to be
used. In this case, go to step 9.
•“Surround Back” can be set when “Amp Assign” is
set to “NORMAL”.
Subwoofer
Select for no subwoofer to be used. In this case, go
to step 10.
9
Use o p to set whether or not a surround back
channel is measured.
Measure
(2 sp)
Set for measuring two surround back speakers.
Measure
(1 sp)
Set for measuring a surround back speaker.
Skip
Set for no measuring of a surround back speaker.
10
Use o p to set whether or not a subwoofer channel
is measured.
Measure
Set for measuring a subwoofer.
Skip
Set for no measuring of a subwoofer.
11
Press RETURN.
Proceed to page17
STEP1 Preparation
step 6.
NOTE
After performing Audyssey
®
Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey
®
Auto Setup again.
5
Use o p to select the
conguration of the connected
speakers.
NORMAL
Select the “NORMAL” setting to perform
7.1-channel playback using the surround back
speakers.
ZONE2
Select the “ZONE2” setting to assign the unit’s
built-in power amplifier for ZONE2 and output the
audio in stereo.
SPKR-C
Select the “SPKR-C” setting to connect the front
speakers via the bi-amp connection.
Front B
Select the “Front B” setting to use the second set
of front speakers for playback.
F.HEIGHT
Select the “F.HEIGHT” setting to use the front
height speaker for playback.
6
Press RETURN to exit the “Amp Assign” setting.
Basic version
Advanced version
Information
Advanced version