Marantz ST7001 User Manual (English)

Other manuals for Marantz ST7001

Service Manual40 pages

Addendum Sheet1 page

Specification Sheet14 pages

Questions and Answers:

A
Alexandra WattsAug 14, 2025
What to do if Marantz ST7001 remote control buttons not working?
- G
  Gregory RileyAug 14, 2025
  If nothing happens when you press the remote control buttons on your Marantz Tuner, here's what to check: * **Batteries:** Ensure they aren't dead. If they are, replace them with new ones, making sure they are inserted in the proper direction (ª and ·). * **Distance and Obstacles:** Make sure you're close enough to the main unit and that there are no obstructions blocking the signal. * **Button:** Ensure you are pressing the correct button. * **Remote Control Code:** Verify that the remote control code matches the main unit's setting. * **Rear Panel Switch:** Confirm that the EXTERNAL/INTERNAL switch on the rear panel is set to the INTERNAL position.
N
natashalarsenAug 17, 2025
What to do if Marantz ST7001 power does not turn on?
- M
  Michael ReevesAug 17, 2025
  If the power does not turn on when you press the POWER ON/STANDBY switch on your Marantz Tuner, make sure the mains cord’s plug is properly plugged into the wall outlet.
M
Marcus RiveraAug 20, 2025
Why is my Marantz ST7001 Tuner hissing on FM broadcasts?
- B
  Bradley PetersAug 20, 2025
  If you are hearing a hissing noise on FM broadcasts with your Marantz Tuner, it could be due to the following: * **Antenna Cable:** Ensure the antenna cable is properly connected. * **Antenna Direction:** Try pointing the antenna in a different direction. * **Weak Radio Waves:** If the signal is weak, consider installing an outdoor antenna.
I
Ian KellerAug 25, 2025
What to do if Marantz ST7001 displays “NO SIGNAL”?
- A
  Angel LozanoAug 25, 2025
  If your Marantz Tuner displays “NO SIGNAL”, it means the signal cannot be received. Try repositioning your XM Connect-and-Play antenna to resolve this issue.
A
Alexandra RossAug 27, 2025
Why is my Marantz ST7001 Tuner making a buzzing sound on AM broadcasts?
- C
  Courtney WaltersAug 27, 2025
  If you're hearing a hissing or buzzing sound on AM broadcasts with your Marantz Tuner, the issue might be: * **Interference:** Noise from a TV or interference in the signals sent from the broadcast station. To resolve this: * Turn off the TV. * Change the position of the loop antenna. * Consider installing an outdoor antenna.
W
wongginaAug 30, 2025
How to fix “CHECK ANTENNA” message on Marantz Tuner?
- M
  Michael MillsAug 30, 2025
  If your Marantz Tuner displays “CHECK ANTENNA”, it indicates that the XM terminal and the XM Connect-and-Play antenna are not properly connected. Double-check the connections to ensure they are correct.
A
Angel SmithSep 2, 2025
What causes booming sound on Marantz Tuner AM broadcasts?
- D
  David SmithSep 2, 2025
  If you are hearing a booming sound (humming) in AM broadcasts on your Marantz Tuner, it could be due to signals transmitted over the main cord being modulated by the power source frequency. Try inserting the plug in the opposite direction or install an outdoor antenna.
A
Aaron AlexanderSep 6, 2025
What does “OFF AIR” mean on Marantz Tuner?
- M
  Melinda HarrisSep 6, 2025
  If your Marantz Tuner is displaying “OFF AIR”, it means that the selected channel is not currently broadcasting. Select another channel.
K
Kimberly RichardsSep 9, 2025
Why is my Marantz ST7001 Tuner receiving only XM channels 0 and 1?
- K
  Kerry CrossSep 9, 2025
  If your Marantz Tuner is only receiving XM channels 0 and 1, it indicates that the XM Tuner is not activated. Contact XM Radio to activate it.

Marantz ST7001 Specifications

General

Tuning Range (FM)	87.5 - 108 MHz
Tuning Range (AM)	522 - 1611 kHz
Signal to Noise Ratio (AM)	50 dB
RDS	Yes
Type	Tuner
Frequency Response (FM)	20 Hz - 15 kHz
Stereo Separation (FM)	45 dB
Dimensions (W x H x D)	440 x 104 x 341 mm 17.3 x 4.1 x 13.4 inch