marposs IWAVE2 - Page 55

Chapter 5  INSTRUCTIONS FOR USE 55
5.3.4.3 Transducer zeroing

Initial condition:
Measure hold.

Access mode:
Simultaneous pressure of the 2 buttons
( red).
 Description:
It allows the transducer zeroing.
Transducer
zeroing
i
INFORMATION
A wrong transducer zeroing can limit the measuring range of the
handle, for example if the operation is performed with an incorrectly
mounted plug.
WARNING
The only way to reset a transducer zeroing is through a factory reset.
Such operation must be performed every time the plug is changed.