Mars m2 multi User Manual

15
4. Operating mode
4.2.3. OFFSEt LO - mode
OFFSET LO mode is designed for situations when the landing location is lower (elevation) than the elevation at which the device was switched on.
In this mode, you can set the elevation dierence of the landing location in the range of approx. +/- 999 m / +/- 2 990ft. Reminder: This is a
temporary setting for one jump only! The settings can only be done when switching on the device. When using the OFFSEt LO mode, the
altitude at which the altitude lock opens relates to the preset landing location elevation. It is also necessary to bear this fact in mind in
case of an emergency situation!
Switch on the device at the take-o point of the aircraft. For correct operation of the m
2
multi it is necessary to preset the elevation dierence between
the landing location and the take-o location. Enter the numeric value of the dierence between the parachutist landing location and the aircraft take
-
-o point. The altitude lock is in this case relates to the landing location, i.e. according to the prole either approx. +450m / +1 475ft for proles Stu,
Int, Pro and Cpi or approx. +900m / +2 950ft for prole Tan minus the specied elevation dierence. In such case, the m
2
multi requires the plane to
immediately climb approx. 40m/130ft above the take-o point for a correct detection of start-up and remain above this altitude for at least 90 seconds.
After these 90 seconds it is possible to descend below the take-o altitude but not below the preset landing location altitude plus approx. 40m / 130ft.
If the skydiver lands at the preset altitude, the device switches o automatically. If the device does not switch o automatically, do it manually after
landing. Switch the device on only before the following jump. This ensures perfect calibration and operation of the m
2
multi device.
Ground
zero
approx. +130ft / + 40m
approx. +130ft / + 40m
90 sec.
Unlocking altitude of Altitude lock
approx. +450m / +1475ft - Stu, Int, Pro, CPi
approx. +900m/ +2950ft - TAn
Restricted area

Mars m2 multi Specifications

General

Brand	Mars
Model	m2 multi
Category	Measuring Instruments
Language	English