Mars m2 multi User Manual

16
4. Operating mode
4.3.1. BASIC mode - example
BASIC mode shall be used always, when the skydiver takes o and lands on the same location, usually drop zone (takes o and lands at the same elevation).
The display shows:
Switched on in the BASIC mode with STUDENT (Stu) prole
4.3.2. OFFSEt HI mode - setting and example
Limit warning! The OFFSEt HI mode can only be used locally on the same isobar!
Example: The landing location is about 250m above the point at which the device was turned on (take-o point).
Briey press the yellow button on the control unit, GO-ON sign appears (for 2 seconds). Do not hold the button, depress it only briey!!!
During the time the GO-ON sign is displayed, preferably immediately after it comes on, depress the yellow button briey once again. The GO-ON sign
appears again. After the yellow button is depressed again (GO-ON sign displayed), the last preset PROFILE can be seen on the display (Stu, Int, Pro, Cpi, Tan).
DO NOT CONFIRM the selected PROFILE and wait for OFFSEt function to show; conrm this function by pressing the button.
The display shows +HI (increased landing elevation). Conrm +HI by pressing the yellow button at the moment the required function is indicated on the
display. (Note: If the device had already been set for OFFSET in the given mode +/-, the display shows the last selected setting for two seconds.)
If the original setting is not conrmed by depressing the button, the display will show the initial letter of the set PROFILE (Stu, Int, Pro, Cpi, Tan), then the
plus sign (+) and in two one-second intervals it displays the numbers to allow exact setting of the required altitude. The rst number is hundreds of meters,
followed by tens and single meters. After entering the required oset, the device calibrates. The initial letter of the PROFILE remains on the display and
above it is the sign oset followed by a plus sign (+) and the set meters. For a better control of the selected PROFILE, it is possible to press the button once,
the whole set PROFILE is shown and above it is the oset sign, after four seconds the GO-OFF sign appears in case you intend to switch o the device
completely, and the INFO menu also comes on that allows access to the information menu.
Switched on in the OFFSEt HI +250m mode with STUDENT (Stu)
4.3. Examples of using modes

Mars m2 multi Specifications

General

Brand	Mars
Model	m2 multi
Category	Measuring Instruments
Language	English