7
3. Profiles
3.1. Description
Prole is a set of parameters that determine the conditions for activation of the m
2
multi device. The most important parameters are the acti-
vation altitude and the fall rate. The parameters of the individual proles are xed. The user may select and set a prole depending on his skills,
used parachute and sports performance or focus. The prole setting is permanent and may be changed in the SETUP menu.
3.2. List of proles
STUDENT (Stu)
INTERMEDIATE (Int)
PROFESSIONAL (Pro)
CANOPY PILOTING (CPi)
TANDEM (TAn)
3.2.1. STUDENT (Stu)
The STUDENT prole is designed for basic training of students and AFF. It is activated when the height above the landing location is lower than
approx. 330
m
/ 1 100ft and fall rate is higher than approx. 13
m
.s
-1
/ 29mph. The altitude lock opens at approx. 450
m
/ 1 475ft. The device
does not activate when below approx. 60
m
/ 195ft. The activation zone is thus in the range of approx. 330
m
to 60
m
/ 1 100ft to 195ft above
the landing location.
Warning:
The speed of approx. 13
m
.s
-1
/ 29
m
ph may be also reached with a fully functional parachute!
If the student-skydiver does not go on with the jump and lands on board the aircraft, switch o the m
2
multi device always in the STUDENT
setting. If this is not possible, the aircraft must not descend faster than approx. 13
m
.s
-1
/ 29
m
ph.
To Next Page
Loading...
Need help?
General