24
6. SEtUP
6. SEtUP
The SEtUP may be entered when switching on the device. SEtUP allows access to the following device settings and their permanent change.
- SCALE (setting the units meter / feet)
- ProFilE (setting the prole Stu, Int, Pro, CPi, TAn)
- AdJUSt (increase the activation height)
6.1. SCALE setting description
The setting is performed when switching on the device. Briey press the yellow button on the control unit, GO-ON sign appears (for 2 seconds).
Do not hold the button, depress it only briey!!! During the time the GO-ON sign is displayed, immediately after it comes on, depress the
yellow button briey once again. The GO-ON sign appears again. After the yellow button is depressed again (GO-ON sign displayed), the last
preset PROFILE can be seen on the display (Stu, Int, Pro, Cpi, Tan). Do not press the button to conrm the prole, but wait for the OFFSEt sign
to appear, after two seconds the INFO sign appears and after another two seconds the SETUP comes on - conrm by depressing the button
shortly.
SCALE is displayed as rst, conrm it by shortly depressing the button.
By conrming access to the SCALE menu, the individual units begin to show in two-second intervals. The rst unit to display is the METER, the
second is the FEET.
Conrm the selected unit by pressing the button.
The unit is set when the device is switched on again.
To Next Page
Loading...
Need help?
General