Mars m2 multi User Manual

2
CONTENTS
CONTENTS
WARNING
1. Introduction
1.1. General description
1.2. Operating principle
2.
m
2
multi description
2.1. Construction
2.2. Processing unit
2.3. Control Unit
2.4. Cutter
3. Proles
3.1. Description
3.2. List of proles
3.2.1. STUDENT (Stu)
3.2.2. INTERMEDIATE (Int)
3.2.3. PROFESSIONAL (Pro)
3.2.4. CANOPY PILOTING (CPi)
3.2.5. TANDEM (TAn)
3.3. Prole charts
3.4. Prole parameters
3.5. AdJUSt description and use
4. Operating mode
4.1. Description
4.2. List of modes
4.2.1. BASIC mode
4.2.2. OFFSEt HI mode
4.2.3. OFFSEt LO mode
4.3. Examples of using modes
4.3.1. BASIC mode - example
4.3.2. OFFSEt HI mode - setting and example
4.3.2.a. OFFSEt HI mode - sequence
4.3.3. OFFSEt LO mode - setting and example
4.3.3.a. OFFSEt LO mode - sequence
5. Controls
5.1. Control basics
5.2. Switching the device on and o
5.2.1. Switch on sequence
5.2.2. Switch o sequence
5.3. Changing the prole
5.3.1. Prole changes sequence
5.4. INFO
5.4.1. Access INFO with device ON
5.4.2. Access INFO with device OFF
5.4.3. Meaning of individual letters
5.4.4. Gravity index
5.5. Error messages
5.5.1. List of errors and their numbers
6. SEtUP
6.1. SCALE setting description
6.1.1. SCALE setting sequence
6.2. ProFilE setting descrption
6.2.1. ProFilE setting sequence
6.3. AdJUSt setting description
6.3.1. AdJUSt settings sequence
7. Important limits and limit modes
7.1. Use in pressurized aircraft
7.2. Altitude lock
7.3. Water jumps
7.4. Instructions for the pilot
7.5. Important operation principles
8. Installation
8.1. Installation procedure
8.2. Securing closing loop
9. Maintenance
9.1. Cutter replacement
9.2. Filter replacement
9.3. Battery
9.4. Annual inspection
9.4.1. Inspection procedure
10. Technical data
10.1. Basic technical data
10.2. Device service life
10.3. Cutter service life
10.4. Warranty
11. Disclaimer
12. Appendices
12.1. X-RAY Card

Mars m2 multi Specifications

General

Brand	Mars
Model	m2 multi
Category	Measuring Instruments
Language	English