Quick Start
You are no doubt eager to switch on the machine and try it out by making a lot
of fog. This section tells you how to do that. However, please also make the time
to read the safety and servicing instructions in the remainder of this manual.
Se tt i n g u p
Locate the machine in a suitably large area with nothing in front of the fog
output.
Fill the fluid tank with an approved Martin™ fog fluid as shown on page 21.
Connect the machine to a suitably rated power source. The power requirements
are:
1200W 220-240V EU / 1050W 100-130V US
1550W 220-240V EU / 1450W 100-130V US
2100W 220-240V EU / 1800W 100-130V US
Now set the mains switch on the rear of the unit, to the ‘ON’ (I) position. The
display will show HEAT. If the display shows OFF, press the FOG button on the
control panel or set the RUN MODE to CONTINUOUS. After about 6-8 minutes
the display should show FOG LEVEL (along with the set output level) and the
machine will begin producing fog. If the display shows READY press the FOG
button on the control panel.
M a ki n g f og
If you want to adjust the fog density manually, press the Menu < > buttons until
the display shows FOG LEVEL and use the Value up/down buttons to select a
value above 0% then press the Enter button to store this value.
If no fog is produced it may be necessary to prime the machine.
Press the Menu <> buttons until the display shows PRIME (located
in the SETTINGS submenu), then press the Value Up button so the
display shows YES, then press the Enter button.
To Next Page
Loading...
Need help?
General
