Martin JEM ZR series User Manual

25
Troubleshooting
Problem
Probable cause(s)
Suggested remedy
Machine will not produce fog
when control panel set to
CONTINUOUS or fog button
pressed
Machine not at operating
temperature
Wait until HEAT message no
longer shown
FOG option set to 0
Increase setting
Machine in timer mode and
TIMER ON set to 0
Increase setting
DMX signal present
Disconnect or turn off DMX
controller
Machine can be fired from
control panel, but not by
DMX controller
DMX address setting
incorrect
Change DMX address (page
16)
Poor connection in DMX line
Check DMX cables and
connections
LINK menu is set to SEND
Set LINK menu to RECEIVE
Fog output is weak
Machine requires priming
Use PRIME option to prime
the machine (page 17)
Wet, greasy, non-uniform
fog output, fluid drips or
spits from nozzle, or very
loud noise when firing
machine
Incompatible fog fluid
Use approved fluid!
Machine appears dead
Mains fuse blown
Replace fuse (page 24)
No power at AC cable inlet
Check power cable and
circuit breaker
Machine causes DMX errors
to occur on other units when
connected to a DMX system
LINK menu is set to SEND
Set LINK menu to RECEIVE
Loss of control from remote
Communication issue
between remote and
machine
Check cable connection
between remote and
machine

Martin JEM ZR series Specifications

General

Brand	Martin
Model	JEM ZR series
Category	Light Fixture
Language	English