Martin JEM ZR series User Manual

16
Control Settings
If you want to temporarily change the fog density, do not press
Enter. The fog setting will go back to its stored value next time the
machine is powered up. This applies to all options.
Se tt i n g t h e T ime r
Set the RUN TIME and OFF TIME values from the menu.
Then select the TIMER option from the RUN MODE menu.
The timer values are set in seconds and are in the range 0-99. The Fog value is
taken from the FOG LEVEL menu. The timer will cycle continuously until the run
menu is changed.
Use this mode for maintaining a low level of fog in smaller venues.
Us in g t h e Se tt ings m e n u
Options such as the DMX base address, display brightness, DMX stand-alone
linking, priming, factory reset and temperature control (ZR45 only) are found in
the SETTINGS menu.
Use the Previous / Next buttons to select the SETTINGS option.
Press the Enter button to go to the SETTINGS menu.
To return to the main menu, use the Previous / Next buttons to select EXIT and
press Enter.
Se tt i n g t h e DM X b a s e a d d re ss
Use the Previous / Next buttons to select the DMX option from the SETTINGS
menu.
Use the Up/Down buttons to set the DMX base address from 001 to 511. If you
hold down the button the address will count up or down more quickly.
Press the Enter button to store the address setting.
The machine will automatically respond to a DMX controller whenever it is
connected.
When using in a DMX system ensure the LINK MODE menu is set to RECEIVE
(the default setting) to avoid causing DMX errors to other devices on the system.
Alternatively, the DMX base address can be set via RDM.
D i s pl ay b a c k l i g h t s ett in g
You can set the brightness of the display backlight using the BACK LIGHT
option.
Use the Previous / Next buttons to select the BACK LIGHT option from the
SETTINGS menu.
Use the Up/Down buttons to change the option to LOW, NORM or HIGH.
Press the Enter button to store the setting.
Se tt i n g t h e m as te r - s l a v e l in k m o d e
It is possible to control several machines from one digital remote. The machine
with the remote plugged into it is set as the Master. The other machines are set
as Slaves. The machines are interconnected with DMX cabling.
Use the Previous / Next buttons to select the LINK MODE option from the
SETTINGS menu.

Martin JEM ZR series Specifications

General

Brand	Martin
Model	JEM ZR series
Category	Light Fixture
Language	English