Use the Up/Down buttons to select RECEIVE (slave unit) or SEND (master unit).
Press the Enter button to store the link setting.
The machine should be set to SEND only if it is running as a master. If running
as a slave, stand-alone or DMX controlled it should be set to RECEIVE. If a
machine set to SEND is connected to an active DMX system, the DMX will be
corrupted causing flickering of lights and other strange symptoms.
P rim ing t h e m a c h i n e a f t e r f lu i d o u t
If the machine runs out of fluid, it will automatically shut down and show FLUID
OUT on the display to prevent damage to the pump(s). To suck the new fluid
back into the machine and reset the FLUID OUT error, replace/refill the fluid tank
and use the prime function.
Use the Previous / Next buttons to select the PRIME option from the SETTINGS
menu.
Use the Up/Down buttons to change the option to YES.
Press the Enter button to start the priming function.
The pump(s) will operate at full power for a short time to purge air from the
pipes inside the unit.
To exit this menu if you decide not to activate the Prime function, select NO and
press Enter.
R ese t t i n g o p t i on s t o f a ct ory s et t i n g s
The factory settings configure a standard mode of operation for the machine.
Use the Previous / Next buttons to select the RESET option from the SETTINGS
menu.
Use the Up/Down buttons to change the option to YES.
Press the Enter button to reset all options.
To exit this menu if you decide not to reset the options, select NO and press
Enter.
To Next Page
Loading...
Need help?
General
