The heaters are Off, the unit is shut down.
The unit is heating up to operating temperature.
The heater is at operating temperature, but Fog is not turned
on (RUN set to STANDBY).
The heater is at operating temperature and the unit is under
DMX control.
Run out of fluid. Refill the fluid tank and operate the prime
function in the SETTINGS menu
The machine has detected an error with its calibration
settings and will not operate. Call Martin™ Service.
The machine has detected an error in the temperature sensor
and will not operate. Call Martin™ Service.
R ese t t i n g t he m a c h i n e a f te r fl uid out
If the machine runs out of fluid, simply refill the fluid container and follow the
priming instructions on page 17.
To Next Page
Loading...
