Martin MAC III User Manual

52 MAC III Wash user manual
EEDF EEPROM PAN/TILT
Writing default data to pan/tilt EEPROM based on its CAN address.
EEDF EEPROM EFFECT
Writing default data to effect EEPROM based on its CAN address.
EEDF EEPROM CMY
Writing default data to CMY EEPROM based on its CAN address.
EFSM FAILSAFE MODE
Module error detected during self-check at startup. Service intervention required. Fixture control
possibly disabled, depending on nature of error.
FAN LAMP R FAN ERR
Right-side lamp fan error.
FAN LAMP L FAN ERR
Left-side lamp fan error.
FAN BOTTOM FAN ERR
FAN CMY FAN ERR
FAN TOP FAN ERR
FAN BASE FAN ERR
FAN PU L FAN ERR
Left-side ballast fan error.
FAN PU R FAN ERR
Right-side ballast fan error.
FAN IRIS FAN ERR
FBEP PAN FBACK ERROR
Pan feedback error: unable to correct pan position.
FBET TILT FBACK ERROR
Tilt feedback error: unable to correct tilt position.
FOER FOCUS ERROR
Zoom position indexing system error. Fixture will work normally but zoom may lose position and hit
mechanical stop.
HTCO HEAD TMP CUT OFF
One or more of the PCB's in the head has reported a temperature above the permitted maximum for
more than 5 minutes. Lamp shut down. A fan may be defective or the ambient temperature may be
too high.
HTSE HEAD TMP SEN ERR
A head temperature sensor is not communicating normally. Fans set to full speed.
IRER IRIS ERROR
Iris position indexing system error. Fixture will work normally but iris may lose position and hit
mechanical stop.
LAER LAMP ERROR
Lamp sensing circuit is not detecting light at power on or has detected sudden loss of light. Lamp is
defective or has exploded, is missing, or cannot strike. Pan and tilt are locked. DMX control is
disabled. Fixture cannot be reset by DMX.
LFER LEFT FROST ERROR
Left-side frost position indexing system error. Fixture will work normally but frost filter may lose
position and hit mechanical stop.
LSER LIGHT SENSOR
Light sensor circuit error. Sensor is detecting light but a lamp on command has not been given.
LTCO LAMP TMP CUT OFF
A lamp temperature sensor has reported a temperature above the permitted maximum for more
than 5 minutes. Lamp shut down. A fan may be defective or the ambient temperature may be too
high.
LTSE LAMP TMP SEN ERR
A lamp temperature sensor is not communicating normally. Fans set to full speed.
MAER MAGENTA ERROR
Magenta position indexing system error. Fixture will work normally but magenta flags may lose
position and hit mechanical stop.
MALE MAINS LOW
Input voltage on electronic ballast is too low. It may be impossible to strike lamp.
OPER ONBOARD PROG ERR
Onboard programming function error.
PAE R PAN E RROR
Pan alignment circuit error.
Short code Full-text message
Table 5: Error messages

Martin MAC III Specifications

General

Brand	Martin
Model	MAC III
Category	Light Fixture
Language	English