Mase Generators SILENT 12 - Maintenance

SILENT 12
27
GB
4.2 Maintenance
For long life and proper functioning of the generator, the checking and maintenance schedule
indicated in the following table must be respected.
How to execute these operations is described, for the part relating to the engine, in the use and
maintenance handbook or in the workshop manual of the engine manufacturer.
During normal maintenance operations (assembly/disassembly) some general rules must be
followed
- respect the tightening torques.
- use suitable grease, oils, and thread-locking fluid.
- do not wash the windings or electrical parts with acid or corrosive substances.
- spray deoxidiser on the electrical contacts
- respect the cable numbering.
If necessary note down the numbering and the position.
OPERATION ................................................................. HOURS
Engine oil level check ..........................................................10
Coolant level check ..............................................................10
Check that there are no oil leaks ........................................20
Check that there are no fuel leaks ......................................20
Check that there are no coolant leaks ...............................20
V-belt tension adjustment .................................................. 100
Battery charger check ........................................................100
Clean the fuel filter .............................................................200
Belt tension adjustment .....................................................200
* Engine oil change .............................................................200
Check the seawater pump rotor ........................................400
Check the engine rpm ........................................................400
Check integrity of the electrical connections. .................400
Fuel filter replacement .......................................................400
* Oil filter replacement........................................................ 400
Check the injectors ............................................................400
Check the injecting timing .................................................400
Intake/exhaust valve play adjustment .............................. 400
Check the fuel injection pump ........................................1.000
Battery electrolyte level check .................................. monthly
Clean and deoxidise the metallic parts ....................... yearly
Air filter cleaning ............................................................ yearly
Complete coolant change ............................................ yearly
* Carry out the first operation after 50 hours, subsequently according to the fixed intervals.
Engine life cycle
Hours
Average time elapsing between one fault and the next 2.000
*First partial overhaul 9.000
*Total overhaul 13.500
*Second partial overhaul 22.500
*End of life 27.000
4 ENGINE