Model: LC5296-AT /LC5248E-AT/LC5296V-AT masibus
Doc. Ref. no. : - m61C/om/301
Issue no. 13
User’s Manual Page 3 of 44
7. CONTROL FUNCTION .............................................................................................................. 28
7.1 ON/OFF Control........................................................................................ 28
7.2 PID Control ............................................................................................. 29
7.3 Ramp and Soak Function ........................................................................... 31
7.4 Motor Positon Control without slide wire feedback: ...................................... 32
8. ALARM OUTPUT ....................................................................................................................... 33
8.1 ALARM TYPES .......................................................................................... 33
9. CALIBRATION PROCEDURE .................................................................................................. 36
9.1 Procedure for CAL-zero and CAL-span ......................................................... 36
9.2 Procedure for RET-zero and RET-span ......................................................... 36
10. COMMUNICATION PROTOCOL–MODBUS RTU ............................................................. 37
10.1 Introduction ........................................................................................... 37
10.2 Parameter Address Details ....................................................................... 37
10.3 Exceptional Response ............................................................................. 39
11. APPENDIX ................................................................................................................................ 40
11.1 Troubleshooting ..................................................................................... 40
11.2 ON-OFF LOGIC ....................................................................................... 41
11.3 Retransmission Output Table for OPEN /OVER /UNDER Condition ................. 41
11.4 Linear Output Table for OPEN/OVER/ UNDER Condition ............................... 41
11.5 Jumper Settings for Addon Card Selection & RetransmissionOutput Type ....... 42
11.6 Load connection ..................................................................................... 44