Rad-57 Signal Extraction Pulse CO-Oximeter Operator’s Manual
3-1
3
Setup
Section 3 - Setup
Introduction
Before the Rad-57 Pulse CO-Oximeter can be used in a clinical setting, it needs to be inspected,
properly setup and the batteries need to be installed.
Unpacking and Inspection
Remove the instrument from the shipping carton and examine for signs of shipping damage. Check
all materials against the packing list. Save all packing materials, invoice and bill of lading. These may
be required to process a claim with the carrier.
If anything is missing or damaged, contact the Technical Service Department. The contact address
and phone numbers are listed in Section 9, Service and Maintenance.
Preparation for Monitoring
The following sections of the manual describe the preparation, set-up and initial installation of the
Rad-57 Pulse CO-Oximeter.
To Next Page
Loading...
