Masimo SET Rainbow SET Rad-57 - Error Codes and Sensor Issues

Rad-57 Signal Extraction Pulse CO-Oximeter Operator’s Manual
5-5
5
Alarms and Messages
*available in upgraded Instrument
DISPLAY REASON SOLUTION
Err
##
System Fault
Return for service.
There are several error codes. All error
codes require return of the Instrument to an
authorized service center for repair. See
Section 9, Service and Repair for return
procedure.
RPL
Cbl
Defective cable Replace cable
RPL
SeN
Sensor life expired Replace sensor
RPL
ADH
Defective adhesive
sensor (resposable)
Replace adhesive sensor (resposable)
RPL
Reu
Defective reusable
sensor (resposable)
Replace reusable sensor (resposable)
INT
DET
(Blinking)
Interference detected
Ensure that the sensor is properly applied,
and cover the sensor site with opaque
material, if required.
INC
SeN
Incompatible sensor
Unrecognized sensor
Insert Masimo sensor
INC
Cbl
Incompatible cable
Unrecognized cable
Insert Masimo cable
INC
adH
Incompatible
adhesive sensor is
attached (resposable)
Attach compatible adhesive sensor
(resposable)
NO
adH
No adhesive sensor is
attached (resposable)
Attach adhesive sensor (resposable)
SEN
000
No sensor uses
remaining
Insert new Masimo sensor
CBL
000
No cable uses
remaining
Insert new Masimo cable