8-12
Final Gear Oil
Checking the Final Gear Oil Level
1. Place the vehicle on a level surface.
2. Remove the oil filler bolt, and then check
the oil level in the final gear case.
1. oil filler bolt 2. Final gear oil
3. Correct oil level
NOTE:
The oil level should be at the brim of the filler
hole.
3. If the oil is below the brim of the filler hole,
add sufficient oil of the recommended
type to raise it to the correct level.
1CAUTION:
Be sure no foreign material enters the final
gear case.
4. Install the oil filler bolt, and then tighten it
to the specified torque.
Tightening torque:
Final gear oil filler bolt:
23 Nm (2.3 m·kgf, 16.3 ft·lbs)
To Next Page
Loading...
