wheel-drive switch is set to the “4WD”
position.
NOTE:
●
Due to the synchronizing mechanism in
the differential gear case, the four-wheel-
drive indicator may not come on until the
vehicle starts moving.
Coolant Temperature Warning Light “ ”
When the coolant temperature reaches a
specified level, this light comes on to warn
that the coolant temperature is too hot. If
the light comes on during operation, stop the
engine as soon as it is safe to do so and
allow the engine to cool down for about 15
minutes.
1
CAUTION:
The engine may overheat if the vehicle is
overloaded. If this happens, reduce the
load to specification.
After restarting, make sure that the light
is out. Continuous use while the light is
on may cause damage to the engine.
High beam indicator
The light being on means headlight is at high
beam mode.
Position light indicator
The light being on means that the position
light fixed in the front headlight has been
turned on.
Emergency indicator
The light being on means emergency lamp is
on.
To Next Page
Loading...
