2 /
Autoclaving
INTRODUCTION
The IMPACT family of pipettors have been specifically designed for
serviceability. This design concept enables the user to service
instruments with relative ease. Under certain circumstances where
on-site service is not feasible, the instrument may need to be
returned to Matrix Technologies for repair.
In cases where pipettors have been exposed to biohazardous
materials, autoclaving internal components may be required.
Matrix Technologies provides the following Autoclave Kit:
Autoclave Kit (Part No. 9997)
12 replacement cross tubes
1 wooden applicator
O-ring lubricant
12 o-rings
Perform the following procedures for proper autoclaving of IMPACT
components.
To Next Page
Loading...