Matrix SATATYA NVR0801X System Manual

276 Matrix SATATYA Devices Manual
Monitor Client (Not Applicable for NVRX series)
Monitor Client displays the health status of device and informs about the occurrence of various events. For this the
Monitor Client service should be enabled from the Network Settings of the Device.
To configure the parameters for Monitor Client, select Network Settings and Click on Monitor Client option. The
Monitor Client Settings page appears as shown below:
Enable Service: Check the box to enable the Monitor Client Service.
Protocol: Select the TCP or UDP protocol for communication of SATATYA Device with Monitor Client.
IP Address: Specify the IP address of the server PC where Monitor Client application is to be used.
Port: Specify the listening Port of the server.
Click on Save to save the monitor client settings.
P2P
When you need to access the Device from behind the NAT, you must enable P2P functionality. You will be able to
access the device from the Mobile Application (SATATYA SIGHT). You need to make sure that, both the Device and
Clients are connected to the Internet.
This feature will not be functional if you have a Symmetric NAT installation.

Matrix SATATYA NVR0801X Specifications

General

Brand	Matrix
Model	SATATYA NVR0801X
Category	DVR
Language	English