Introduction – Certification
T50/T100 PTM – User Guide – Version 2 Issue 1
2
Certification
Matthew’s print heads are certified in accordance with the requirements for CE marking. The
equipment complies with the EMC Rules for a Class A (industrial environment) computing
device.
Operation of the equipment in a residential area may cause unacceptable interference to radio
and TV reception.
Matthews Marking Products disclaims all responsibility regarding the CE directive if a print
head is used, altered, or installed in any way other than described in this manual.
About this Manual
This manual contains technical information with regard to safety, installation, and
maintenance of the T50/T100 print heads that are controlled by a Viacode PCM (Print
Control Module). It is important that all information regarding safety is read and adhered to.
For information regarding the configuration and control of print heads, refer to the Technical
Manual for the PCM.
It is recommended that the reader begins by reading the section named ’Safety Requirements’
before continuing.
Technical Support
For technical support within the USA call:
Table 1 - Technical support details
Time Telephone number
8:00 AM to 5:00 PM Eastern Time, USA–weekdays 1+ 412 665-2500
5:00 PM to 8:00 AM Eastern Time, USA–and weekends 1+ 412 365-8324
To Next Page
Loading...
