13
Installation
T50/T100 PTM – User Guide – Version 2 Issue 1
Installation
Before installing or operating a T50/T100 print head read and adhere to all safety warnings,
as provided under “Safety Requirements” on page 3.
The T50/T100 print heads must be installed as described below. Failure to install them
correctly can lead to poor print quality or ink leakage.
Print Head Set-up
Print heads are delivered with the head mounted so that it points to the left, as seen when
standing behind the Ink-Reservoir. The head can also be mounted so that it points either to the
right or straight ahead of the reservoir, as shown below.
Figure 7 - Head mounting options
If required the print head can be re-positioned for a given installation. To re-position the print
head follow the procedure described below.
Procedure – Repositioning the Print Head
The following procedure must be carried out by a Matthews certified technician only.
Damage to the print head can occur if the procedure is not done correctly.
Left Mounted Straight Mounted
Right Mounted
To Next Page
Loading...
