Never disassemble or remodel the machine – it could result in a fire, electric shock, or trouble.
Do not insert any foreign object into the machine, such as a finger, pen, wire, etc., – it could result in a fire, electric shock, or
injury.
Use the supplied power cord.
Not using it could result in a fire or electric shock.
Obtain power directly from an AC120V 60Hz electrical outlet. Do not put multiple loads on the electrical outlet – it could cause a
fire.
Do not modify the power cord.
Never place a heavy object on a power cord – it may damage the cord, resulting in a fire or electric shock.
Do not use a bundled power cord.
The emitted heat may cause a fire or malfunction. Be sure to unbundle the power cord before use.
Do not connect or disconnect a power plug with a wet hand – You could receive an electric shock.
Do not operate the machine with wet hands or wet clothes.
You could receive an electrical shock.
Do not place paper or cloth on the machine when it is connected to an outlet.
Doing so could cause a fire or malfunction.
When disconnecting the power plug, hold it directly; never pull on the power cord.
Pulling on the cord can damage it, resulting in a fire or electrical shock.
Ensure that no water or chemicals are splashed over the machines. If water, etc., gets inside for some reason, disconnect the
power plug immediately from the electrical outlet, and contact your dealer for repair. If the machine is used in such a state, it
could malfunction or result in a fire or electric shock.
Never put a hand or an object into a cutter section – it can both cause machine trouble and personal injury.
Run the machine only on the indicated supply voltage – use of any other voltage could result in a fire or trouble.
Be sure to ground the machine.
Otherwise, if a short circuit occurs, a fire or electric shock may result.
Clean the power plug periodically.
Dust accumulated over a long period could cause a fire or trouble.
Keep a cutting tool (blade) out of the reach of children. If swallowed, seek immediate medical attention.
Do not use the machine if it has a symptom of a problem, such as smoke, abnormal sound, or foul odor – such use could result
in a fire or electric shock. In such a case, immediately disconnect the power plug from the electrical outlet, and contact your
dealer for repair.
Do not share an electrical outlet with any device (air conditioner, refrigerator, microwave, office automation equipment, etc.) that
requires a large capacity – it could lower the supply voltage and cause the machine to malfunction.
Install the machine on a flat surface. Do not install in an unstable location, such as on a wobbly platform or an inclined surface.
The machine could fall over or fall from the platform and cause injury or malfunction.
Do not use the machine under direct sunlight, in a hot, humid location, or when there is condensation.
It may cause unstable operation or a malfunction.
Do not place paper or cloth on the machine – it could result in a fire or trouble.
Never touch the thermal head. Immediately after printing, it is very hot and could burn you. Also, if the thermal head is thumbed,
it may cause trouble.
Clean the power plug periodically – dust accumulated over a long period could cause a fire or trouble.
When disconnecting the power plug, hold it directly – never pull on the power cord. Pulling on the cord can damage it, resulting in
a fire or electric shock.
When printing or cutting does not function properly due to jamming of an adhesive tape roll, ink ribbon, or foreign object inside
the machine, be sure to turn off the power before eliminating jamming – Otherwise, you could be injured by abrupt activation of
the machine could cause an injury.
When opening or closing a door cover, be careful not to get a hand, etc., caught.
When moving the machine, be sure to disconnect the power plug from the electrical outlet, close the door cover and hold the
To Next Page
Loading...
Need help?
General
