Max LM-550A2 Series User Manual

1
Install a new ribbon to the ribbon case
How to load consumables
1. Open the cassette cover.. 2. Push the head release lever (blue) until it stops.
1. Holding the “Winding core”, pull the “Ribbon core”
lightly so that the adhered portion comes off.
When pulling the “Ribbon core”,
let the core turn so that the ribbon is not gone slack.
2. While pressing “Button B,” set the ribbon core
(green or blue) as shown in the figure.
Then, release the “Button B” to lock the ribbon.
Do not push too deep or too hard on the Button B.
Pay attention to the top and bottom of ribbon case.
3. While pressing “Button A,” set the winding core (black)
as shown in the figure.
Then, release “Button A” to lock the ribbon.
Do not push too deep or too hard on the Button A.
4. Rotate the ink ribbon toward the direction of the arrow until the black surface appears.
(The color changes in the order of transparent → blue → black)
When the surface (black) has appeared, stop rotating.
Make sure the ribbon is not slack.
Rotation
The color changes.
Press
Button A
Insert
Insert
Press
Button B
Push the lever
Proper loading
Hold the ink ribbon case
as illustrated below and
load it completely.
Ink ribbon
Press it lightly,
to check it is
set completely.
1. The supplementary manual of LM-550A2 series

Max LM-550A2 Series Specifications

General

Brand	Max
Model	LM-550A2 Series
Category	Label Maker
Language	English