Max LM-550A2 Series - Vertical; Repeat

48
FUNCTIONS
8-6 VERTICAL
Setting to print the texts in the vertical orientation.
Note: The printed result varies depending on the selected “PRINT MODE.”
You can select “PRINTING DIRECTION” according to the following table.
PRINT MODE MATERIAL HORIZONTAL VERTICAL
PITCH
PRINT
Tube
Tape /
ID Plate
NORMAL
PRINT
Tape /
ID Plate
1. Press SHIFT C/SPC (VRT). The [VERTICAL
setting screen] appears.
2. Press / key to select.
3. Press ENTER .
Note: Both of “VERTICAL” and “HORIZONTAL” cannot be set in a same document.
If the error message (“SIZE-OVER”) appears, check the size of the material, character
size, and the number of lines. (See 11-1: ERROR MESSAGE LIST)
8-7 REPEAT
Setting the number of multiple copies of a particular block.
COM
“REPEAT” = 1pc.
“REPEAT” = 3pcs.
Selectable items: YES (vertical), NO (horizontal)
Setting range: 1 300pcs.
COM
COM
C
O
M
COM
C
O
M
1. Press . The [REPEAT settingRPT
screen] appears.
2. Press / key or Ten key to input the value of the
“REPEAT.”
3. Press
.
ENTER
Note: The default value of “REPEAT” can be changed in the “OPTION” setting.
B
P
B
P